1

Cut the angled sides using a straightedge to guide your saw. Cut the rectangular pieces with a table saw or a circular saw and straightedge.

2

Saw out the hose holder parts with a jigsaw. Trace around one half of a paint can and one half of a 5-gallon bucket to mark the pieces. Glue and screw the half circles together to make the hose holder.

3

Position the dividers with temporary spacers. This eliminates the need for measuring and marking and makes alignment much easier. Use the same spacers again when you install the shelf below the dividers.

4

Wrap the top of the station with a sturdy lip to prevent the compressor from “walking” off. Use both glue and nails for a strong connection.