WHAT IT TAKES
TIME: 1 day
SKILL: Beginner to intermediate
Build this mobile tool chest and take all your tools to the job in just one trip. All you need is a new dolly and some pine boards. If you use 1x10 pine boards, you won’t need to cut any boards to width.
Screw the cabinet together with 1-5/8-in. drywall screws after drilling pilot holes. Clamp on the plywood back, check for square, then screw it to the sides, top and floor with 1-5/8-in. drywall screws. Attach the doors with 2-1/2-in. butt hinges.
Pine boards tend to warp, so to keep the doors flat, screw several 2-in.-wide cleats across the inside. The cleats can be drilled to double as great drill and driver bit holders.
To raise the cabinet to a more comfortable height, screw four scrap boards into a frame and attach this base to the dolly’s base with lag screws. Next drill holes in the base, then rest the cabinet on the base and attach it with 1-5/8-in. drywall screws through the floor into the base. To attach the upper part of the cabinet to the dolly, drive two 5/16-in.-diameter bolts through a board positioned behind the dolly’s frame and into two 5/16-in. tee nuts set in the cabinet back. If this won’t work for your dolly or design, use metal strapping or drill a couple of bolt holes through the dolly.
The cabinet’s 9-1/4 in. depth provides plenty of space for power and hand tools plus full sheets of sandpaper. Have fun engineering convenient holders for your tools using pegboard, magnets, hooks and shop-fashioned holsters. Be sure to securely store tools so they won’t fall or roll around as you cruise to and from the job.
Materials List
ITEM |
QTY. |
36-in.-long 1x10 pine boards (actually 3/4 in. x 9-1/4 in.) for the doors and sides |
4 |
18-1/2-in.-long 1x10 pine boards for the cabinet top and floor |
2 |
18-1/2-in. x 36-in. piece of 1/2-in.- thick plywood for the back |
1 |
Scrap boards for a base |
|
Assorted fasteners |
|