Creating Centerlines and Center Marks

1. Click Annotation > Centerline on the CommandManager.
2. Select the parallel lines on the section view, as shown below. The centerline is created.

1. Click OK on the PropertyManager.
2. Click Annotation > Center Mark on the CommandManager.
3. On the PropertyManager, under Manual Insert Options section, click the Circular Center Mark icon.
4. Select the outer circles of the counterbore holes

1. Click OK on the PropertyManager.

1. Activate the Center Mark command.
2. On the PropertyManager, under the Auto Insert section, check For all slots.
3. Check the Circular lines option and uncheck all other options.
4. Click the Arc Slot Ends icon under the Manual Insert Options section of the PropertyManager.
5. Activate the Slot Ends icon.
6. Select the front view and click OK.