Reassembly Tips:

1. When replacing the carrier spring, use small sharp nosed pliers to grasp the rear arms of the spring and guide them into their notches in the sub-frame.

2. When replacing the bolt, pull the trigger to ease insertion in the receiver. Also, when replacing the hammer assembly, pull the trigger to allow the hammer to move forward to fired position to facilitate replacement of the receiver end piece.

3. When replacing the end piece, tighten it by hand only, no tools; then back it off until it is in the position shown to mate with the stock.

When replacing the barrel in the receiver, take care that the small spring above the cartridge guide is not deformed as the barrel and attached guide are slid into place.