Goldfish by Rob Snyder

This fish is developed from a traditional “windmill” base. By adjusting steps 7 and 8, you can create a number of different tail shapes.

1 White side up, fold in half, crease and unfold.

2 Fold upper and lower edges to the center.

3 Fold all four corners in, crease and unfold.

4 Reverse all four corners inside.

5 Fold two flaps to the right.

6 Fold the lower half underneath.

7 Fold all layers down.

8 Fold so the circled points meet.

9 Unfold the last two steps.

10 Make these creases on both sides, folding paper inside.

11 Fold a single flap down on both sides.

12 Fold a small fin over on both sides.

13 Crease and unfold.

14 Crease and unfold again.

15 Squash the corner to the right.

16 Fold the square in half downward.

17 Open both sides of the square at right angles. Open the “mouth” a little.