A Local Network

Emboldened by the success of site.toddle, we can now set about a more realistic setup, without as yet venturing out onto the unknown waters of the Web. We need to get two things running: Apache under some sort of Unix and a GUI browser. There are two main ways this can be achieved:

• Run Apache and a browser (such as Netscape or Lynx) on the same machine. The “network” is then provided by Unix.

• Run Apache on a Unix box and a browser on a Windows 95/Windows NT/Mac OS machine, or vice versa, and link them with Ethernet (which is what we did for this book using FreeBSD).

We cannot hope to give detailed explanations for all possible variants of these situations. We expect that many of our readers will already be webmasters familiar with these issues, who will want to skip the following sidebar. Those who are new to the Web may find it useful to know what we did.

Our Experimental Micro Web

First, we had to install a network card on the FreeBSD machine. As it boots up, it tests all its components and prints a list on the console, which includes the card and the name of the appropriate driver. We used a 3Com card, and the following entries appeared:

...
1 3C5x9 board(s) on ISA found at 0x300
ep0 at 0x300-0x30f irq 10 on isa
ep0: aui/bnc/utp[*BNC*] address 00:a0:24:4b:48:23 irq 10
...

This indicated pretty clearly that the driver was ep0 and that it had installed properly. If you miss this at bootup, FreeBSD lets you hit the Scroll Lock key and page up until you see it then hit Scroll Lock again to return to normal operation.

Once a card was working, we needed to configure its driver, ep0. We did this with the following commands:

ifconfig ep0 192.168.123.2
ifconfig ep0 192.168.123.3 alias netmask 0xFFFFFFFF
ifconfig ep0 192.168.124.1 alias

The alias command makes ifconfig bind an additional IP address to the same device. The netmask command is needed to stop FreeBSD from printing an error message (for more on netmasks, see Craig Hunt’s TCP/IP Network Administration [O’Reilly, 2002]).

Note that the network numbers used here are suited to our particular network configuration. You’ll need to talk to your network administrator to determine suitable numbers for your configuration. Each time we start up the FreeBSD machine to play with Apache, we have to run these commands. The usual way to do this is to add them to /etc/rc.local (or the equivalent location — it varies from machine to machine, but whatever it is called, it is run whenever the system boots).

If you are following the FreeBSD installation or something like it, you also need to install IP addresses and their hostnames (if we were to be pedantic, we would call them fully qualified domain names, or FQDN) in the file /etc/hosts :

192.168.123.2 www.butterthlies.com
192.168.123.2 sales.butterthlies.com
192.168.123.3 sales-not-vh.butterthlies.com
192.168.124.1 www.faraway.com

Note that www.butterthlies.com and sales.butterthlies.com both have the same IP number. This is so we can demonstrate the new NameVirtualHosts directive in the next chapter. We will need sales-not-vh.butterthlies.com in site.twocopy. Note also that this method of setting up hostnames is normally only appropriate when DNS is not available — if you use this method, you’ll have to do it on every machine that needs to know the names.